FMS Interface

Gameport Interface

This site best viewed with Internet Explorer at 1024 x 768.

Interface Adaptors

If you have two transmitters or an existing interface cable but don't want to change the connector, then just use an adaptor cable as above.

These adaptors can be used to change a different transmitter connector without physically changing the connector.

The adaptors are only for simulator interfaces and are not intended for use as a buddy cord adaptor. Only two or three wires are used as required for interface use.

You can make your own adaptor if you can obtain the connectors. Just follow the wiring diagrams in the Transmitter Trainer Connector Pinouts. 

Note:
When wiring the female connector the pin numbers used will be the same but remember that the pins will be on the opposite sides. For example, with the Futaba 6 pin Din male connector the signal is on pin 2 which is on the left. When connecting to a Futaba 6 pin Din female connector the signal is still on pin 2 but now pin 2 is on the right side.

If you need help with the wiring you can check with the TX 2 TX site. You should be able to make any adapter cable you will ever need with the information at that site.

If you just want to buy one I have them available. I have most in stock and I can make whatever combination you need but some combinations  may take an extra day before shipping.

Interface  Adapter  Selector

I am temporarily out of stock on the Futaba 6 pin round female connector.

To order an Interface Adapter with a female Futaba 6 pin Din

and a male Futaba 5 pin DIN connectors at a cost of $5.00 US

 click on either of the Paypal buttons above.

The shipping cost will be added to the cost of the adapter.

I am temporarily out of stock on the Futaba 6 pin round female connector.

For multiple orders please contact me and I will provide shipping costs for your order. The buttons above are meant for single item orders.

Click here to view locations where orders have been shipped.